Hello, I just can’t get out of the problems with the Kreidler Flory 50 Speed (2stroke 50ccm) . I had bought these defective (always only a short run ) . First I had cleaned the carburettor and changed the E-Choke , afterwards it ran a few days , until during the driving heavy rain came , then he went out and did not want to hit again . A day later I tried to start it again , which after shortening the ignition cable on both sides (true wet ) also erfo However, one day later he did not want to go to, then I ordered a new carburettor (https://www.zweiradteile.net/…/…orto-phva-for-aerox-nitro-tph-cpi), a new e-choke (https://www.zweiradteile.net/…/…mb-peugeot-piaggio-gilera-dellorto) (the old one had 8mm) and a new air filter (https://www.zweiradteile.net/…/…d-for-minarelli-liegend-aerox-jog) (because the old one was leaking and was not suitable for the new carburettor). However, the scooter started again, but I then installed all the ordered parts, because the old carburetor was at the oil and petrol connection point. Now, however, the scooter doesn’t run anymore, unless I spray brake cleaners into the air filter, then the scooter turns up very briefly and goes out again. Ps. The carburetor comes according to the side where I ordered it (and apparently has three nozzles in the float chamber, not like my old one with two). I’m already ready for your help and try to give all relevant info and updates.