Hello, Today I dared to change the brake linings on my GPZ500 and I did not get the cylinders back. Unfortunately, I didn’t quite get the cylinders back, because they are now grinding heavily! I didn’t drive yet but I already pushed up the mountain alone! This was also so before, but not so strong. Do you have to sink the cylinders completely? I pushed them back with a big screwdriver and first with the old ones! Trot zdem I have now rienfen in the new coverings and a small corner has even broken off on a covering! I tried to clean the last piece that looks out of the cylinders with a toothbrush and brake cleaner also brought a bit, but I just can’t imagine that it fits now! Do they not glazing then when I drive around so now?