Hello, I drive a Mazda Demio Built. 2000 1.5L, Rungle. 95tkm. My problem is: The first gear is often difficult to get inside. Sometimes it works well and sometimes I have to beat it in. If the engine is warm, then the improvement is only slight. When the gear is backwards, it is just like that! If the gear is rolling, then the gear goes in without resistance. But in the stand I feel a great resistance if I want to take the first gear. That is very often the case and mega annoying. In other gears give I changed the gear oil three months ago and I did it fully. 75W-90 filled by Mannol and transmission additive from L. Moly. No improvement! Now I think about whether I should put in the gearbox ATF III Dexron, because I think that the synchronous rings may no longer grip. That would make the thick ATF remedy (maybe ?). What I also plan to do is to roll the gear. The gear lever has 2-3 cm in all gears. Neulic h I sprayed blind-humid spray grease on the rods under the car, but did not notice any difference. I post two pictures of the switchbar under the car!