Hello, I hope that I can get help with a general electrical problem here. I have a question about my lighting. I drive CNC handlebar valves with normal push buttons with rest function (so no pushbuttons). I also use a vape with H4 headlights on my Simson S51-4. This combination eliminates the possibility to disconnect dipped and main beam. High beam works seperately (a light turn in the bulb lights). However, when switching to dipped beam lights the bulb becomes so hot after a short time that it breaks down. From my handlebar armature a cable goes to ignition lock Kl.56 (like original white/black), from terminal 56 a cable (yellow) goes to 56B dipped light on the headlight or bulb. From the headlight or bulb 56A (remote light) the cable goes to the switch in the armature. Mass is fetched directly from the frame. I have the possibility to switch here by means of a relay circuit so that both sparks again separately If yes, can someone help me with the relay circuit?