With my Sandero (BJ 2009) the headrests in the highest snap-on setting are still significantly too low. I did not grow for a short time, but no seat giant, i.e. even in the mode it was possible to bring the headrest into the recommended setting / height. It is well known that the most prominent part of the back of the head should be in the middle of the headrest, since in the event of an impact and later throw back the body, the head yes ” If the headrest were to be adjusted in such a way that the top rounding of the headrest lies at the described point of the head, then the head would be thrown back above the headrest and the neck would break. The headrest in my sandero is so low that even I press it from the bottom with my back/shoulder. This can be done by myself. I didn’t want to be. As I said – in the mode the correct setting was no problem – even with no other car I used to drive before. I was already with Dacia. The seller recognized the problem but could not offer a solution after consultation with the technology. I notice that the poles with which the headrest is in the backrest would be long enough. However, there are no “notches” available, which let the headrest snap in in the desired position. Is it similar to you? Can such notches be milled or similar afterwards? What would you say about it? vg navimodus