Hello, I have always had a problem with my EXC 300 EZ 94 after driving through puddles and hope to vind the cause here. Shortly after driving through a pool of water (also flat which are only 10cm deep), my engine starts to jerk in the upper lathe area. A short time later the box goes out and hardly again. I then have to find a quarter of an hour to run it again. In between, it hissses explosively from the exhaust at the start! I have a problem with my EXC 300 EZ 94. already the cable from the Lima double wrapped up and the Bowden train is sealed at the carburetor, unfortunately without success! Whenever the Mtor gets a load of water from the front wheel gets loose Does anyone have a solution for this????