Hello, I am about to make a bearing change at mrinrm Swift transmission, old ones are already pressed out and new ones are used. For this directly the first question, is there a built-in dimension, I have used them now so that they are plan with the transmission. If there are installation values, maybe someone has it? Next I want to install the shafts again, however I am not quite sure about the construction of the input shaft. How about the switchboards have to be inserted, with the nose down or up (see pictures) and which functions do they fulfil at all? Next question would be whether the synchronous rings have to be positioned correctly so that the switch stones sit correctly (they also have small savings) or is their installation position no matter as long as they show with the wide flanges direction shift socket, as in picture 2. And I ask already with caution in advance, in order to get the shift head back in later, then some special gear must insert or is there anything else to consider? If someone has a repair manual, a link would be great, I have not found anything anywhere, and no videos on the subject either. Lg René