Hello you, I drive a 99-er MX-5, should have been to the tuv in 01.2010 and renewed my brake blocks at the front as well as at the back.With the locks, which were almost down the Mazda braked quite well, now with the new locks brake the just magnificent (the note for the TÜV I think).The braking system was not open, so I can not assume that I have a pressure loss because of air in the braking system.But somehow it does not brake as it should. I’m probably thinking that ABS won’t turn on any more.Did I put my ABS out of the way and weaken my braking system?Does it seem like I’m going to do a full braking on wet roads and only physically block the wheels as they are funny.The fuse from the ABS is I.O.,but somehow I don’t think it works anymore.Can it be? Refreshing brake fluid can’t be the cause of the problem,or And if the brake discs had been understated, they would still be able to complete a full brake, just like with the old brake blocks, wouldn’t they????? Weird.Can I try or control anything without a workshop??? Would I be very happy about help.