Split dimensions series production door

Hello together, I find it amazing with which split dimensions automobile manufacturers partly let new cars leave the production workshop, so that these then from the car dealership to the customers. As can be seen in the pictures (hopefully) the right rear door knows a very large split dimension. The gap at the lower end of the door is so large that one can easily grasp with the small finger behind the sheet and thus behind the door (this has been tried out). Unfortunately, so The workshop manager, nothing can be adjusted here any more. He said that 2 tolerances were met (something at the door stop and the bending of the door sheet), any tolerance for itself within the series production, but then in the overall result “something can come out. Also the manufacturer, where the case was forwarded to the technology department, is of the opinion that this gap “corresponds to the tolerances of a series production”. I can only express my condolences when it comes to quality standards at the same time. By the way, I have not been able to find such a gap in any other vehicle. For comparison, it is quite clear that the gap in the left rear side is completely in order. It is really sad that one should accept something like this. As I said, we are talking about a two-month-old new car.