Good evening! I made a total mess when replacing the water pump with the tooth grate. According to the description of the tooth grate installation you should turn the engine 2 revolutions… unfortunately I turned in the wrong direction and it clacked (valve?) then again in the other direction and the engine blocked (pistons at valves?)… The markings(crankshaft disc – where the big wedge grate wheel comes in) and I can no longer get the ones from the two rails of the camshafts t. It’s so succinctly everything is set ;-(((( How can I get this back? How can I reconcile the markings???? How does the braces work? There’s no stop when I turn the adjusting plate (which with the imperbus cutout) (according to the instructions this should work) or the 13 nut of the tension roller has to be a little tight to adjust? How do I build the braces properly??? Thank you!!!!!! Omega B 2,0 16 v