Hi dear forum community, I bought an older Santa Fe for my son. Technically, he is still top, but he has a few scratches here and there, which I might get out with a paint pin and grinding polish. However, he has a real 10 cm x 2 cm dent on the rear wheel on which the rust already blooms. Now I wanted to grind the spot down to the sheet metal and then rebuild it with it. However, there is a very large selection of different manufacturers. Which one would you recommend. I would start with a silicone remover, then follows primer / filler, then follows fiberglass filler, then follows primer / filler again and finally varnish and clear varnish, or maybe there is a varnish, by which everything is united. So, which manufacturer is really good for my project and maybe you can help me with the scratch removal because there are also several manufacturers there. VG helti