Hello together, my friend suddenly lost power steering after starting. Yellow light burns permanently, restarts unfortunately did not get better like with the computer. I tried to read the error with an old Delphi version (2013). Here was the error: Can not reach control unit, or no signal. I assume if the pump had switched off because of too low level, would be another error here? By the way, I have the level I’m looking for the best solution for the dilemma. My attempt would now be to get a used pump and install it myself. Is this possible without coding? I can’t read out anything from the old pump. The next question would be how best to remove the pump without a stage? Must the bumper be checked, there is too little in it (there’s a drop on the bottom of the rod). or rather the wheelhouse shell? Or is there anything else you could check / do here? Data about the vehicle is a bit vague, is definitely a 6J with 105hp hand switch, year of construction should be so 2012. Part number of the pump is: 6R0423156B I am grateful for advice & suggestions. VG