Please excuse me if I have chosen this forum, I find unfortunately no other on the topic diesel engine! Hello, according to my knowledge, a Hydrojetting water jet 3000 bar device needs approx. a 150 HP diesel engine. Is this a special engine or is this diesel engine the same as in a car? What ingredients do I actually need to run such a diesel engine? – Diesel engine even with everything that is attached around it – battery – water cooler, should it then be 3x as large ß be how normal? What do I do with amaturation? Or is there a diesel engine without gears or can one simply decompose the transmission part? How can one control the speed? A FU control can not be built on! Is there a part to make automatic load control? ————————————————————————– Next assembly variant: Diesel engine – drives oil pump – hydraulic control (left*/right) – *Oil motor drives hydrojection water jets. —————————— —————– right* – *drives a screw spindle compressor with 20 or 25 bar part to save a second diesel engine. Thus, you can operate a dry ice blaster or a compressor hammer etc. ——————————— Which size has an oil gun, etc.? How do I get out how much load such a pump has to have? Can someone show me a picture or give me further information! Because some devices or motors must be about 1.5x or 3x larger by the duration of the pump. be suitable for use! ——————————– Since you need a power generator for every use, it would be good to power the power generator with an oil motor. A power generator with 30 KVA is already available.