Hello I have the problem with my AAN that now always lights up the engine control. This occurred after a cold start, before nothing was noticeable. According to tester there was something like this: Intake air temperature sensor interrupt + After I put up in the sufu, I found that with the 20V Turbo models the cables with the temperature sensor often stop at the plug. Then I replaced a piece of this cable. After I deleted the error leu Fault: Encoder for engine speed G28 no signal. These encoder are there at the swing. Which of the two encoder is that?? Is there something known whether the encoder is over now or if it can be due to something else?! Will it go over night? MFG