Hello, I would be happy to be an absolute car noop about a little help in the installation of a new car radio … I’ll tell you a short story about what happened so far.. Once upon a time.. an expanded swift cassette deck, (if of interest is a swift gls) and from the gaping open hole that was left behind, came a large cable bundle with plugs, so, plug in the old radio disconnected, then the new radio taken, and the power cables + 4 boxes cable to the plug made it with lust Rklemmen, that was so far not a problem, because the old and the new radio had good labels. Summary: New radio with Suzuki own plug on, connected, (even such a small plug cable that must be connected behind the column and my view is the mass (??) ). Turned on, juhu, radio runs. So far all sounds good. Dangers, wobble contact, music was always gone, and n bit pulling out and plugging in the radio helped, is yes but no solution, so all the box cables checked, driven, ran, and then everything was gone. The music was not louder than before and nothing had been changed at the current … Are now the boxes by ? The radio ? The present stand is that the display lights up on half strength, the radio cds adopts and releases, cd reads, but no sound of itself, although the equalizer on the display shows what. Logically, not enough current, but it had broken before or not? End stage? Why? I have ordered a new one now and have asked the following questions – Is there any special security for the radio at the swiss somewhere? Main security box is all in order.. – Since the swiss has no iso plug, I can do that with the new one again ? Take old plugs, and new radio to old plugs connect via luster clamps ? – What do I have to pay attention to not to break another n radio ? Vieeeelen thanks in advance ! If someone somehow, sone instruction for idiots to install a radio, I would be happy about a link.. Thank you !