Hello car friends, I am slowly at the end with my Chrysler PT Cruiser. For a long time I have been looking in my garage for the errors of my Chrysler. I checked everything in the logical principle. Ignition, injection, air and also almost everything renewed and the problem is still there and the indicator light lights up in the interior. I changed the idle switch (because of error P0505) and have recently changed ALL injection nozzles , because of the error 0203!!! Cruiser 2.0 liter engine with 141 hp has always worked when it was cold quite normal, when the engine is warm it jerks, takes badly the gas and eats gasoline without end. It also smells really like gasoline when it has the quirks. I changed everything and checked what only went on. So at least to what extent my mind and technical equipment has passed. It has now been renewed: – Air filter Zünkerzen Zünkabel(ALL) Injection nozzles(ALL) throttle valve with all sensors(empty position) r and throttle flap poti) and it still shows up the errors 0505 and 0203?????I did not have the fault memory deleted yet, but the battery jammed off and again. Then the engine light was out for a while, after 10min driving it went on again. What else I suspect is a drop in the petrol pressure, I could not check yet if it fits. What else can this be???? Lambdasonde?? Possible the ignition coil??? Electrical problem with plug from the injection nozzle ??? Re nice, if someone knows more about the engine and can help me…