After months of searching, I finally bought a car. It’s a Opel Corsa D with 90 hp, it was bought a few days ago for around 3000€. I had opened the hood to clean the engine. Then I told my girlfriend that I was finished. She wanted to close the hood, but she thought that the hood would be hydraulically operated. So she was trying to push the hood against the “stand”, and now the hood is bent. The hood is right bent, quite strong even. It goes to, but you can clearly see that there is also a dent of “below” where the holder / stand is. Can I do something cost-friendly? Doesn’t look good, but is honestly not such a big problem either. Experience halt. Be a photo post tomorrow as it looks. But it’s a pity that the hood was made so cheaply…… To be honest, it didn’t expect a bonnet to be so simple verb Maybe it’s because my cars have been quite old and robust so far.