I’m going to open up my own topic, as I think this is an extremely important topic, which goes down easily in the big EQE thread. Who of you also has problems with the EQE on the new 300kW chargers from EnBW? Was already at some EnBW charging parks and there almost always had problems with the charging. Authentication with the card works. But if it then jumps to the charging screen, where the charging power, charged kWh, SoC is displayed, and actually starts charging. t, there is a charging error that is displayed flashing both at the column and red at the charging socket of the EQE. I have really spent a lot of time with tests and would say that it might work with one of 10 charging stations. Even if it works once and I finish it and start it again for testing at the same column, it is very likely that it will come to the charging termination immediately at the column as well. I have also waited until charging stations became free and this e Column used to charge other cars (even an EQS and an EQA). Also aborted. PS: I have no problems with the 150 kW chargers from EnBW so far. And many other columns like Ionity or Shell as well. @holgor2000: would be great if you could share your information with us here. Especially if you are in contact with Mercedes to fix this.