Hello municipality I made an oil change on my snow cutter about 2 weeks ago and in this breath installed a new ignition coil as the old one said goodbye. After this action the whole spectacle went off. I just can’t get my milling machine started normally anymore and when it makes after the 15x tear times 2-3 bars it pushes out extremely much gasoline to the carburetor. It spits really. In my opinion that can’t happen with a 4 bars the petrol I had already pulled the cylinder head and checked valves and valve play at times, everything was fine and they were completely closed. I then ruled out problems with the valves. My next thought was that the carburetor gives quite a lot of fuel or swimmers or petrol taps do not completely make you and always let out gasoline but after the control I couldn’t do anything wrong. ..everything closes and seals off as it should. At the gasser itself there is no mixing screw to adjust the gasoline-air mixture. My next thought was that the candle does not ignite properly Bzw. There are no proper sparks. But this was also not so.. a rather strong spark flashed on but the candle was quite worn out but not wet but only black. Ahja..the snow blower has no lift filter I really despair because I have no clue ha be on what it might be. I am grateful for any help with kind regards