Hello together, I applied a seal for the first time myself today. However, for the time being only on the bonnet. I used the sonax Polymer Netshield. I have a few questions for this. So I first washed my car and dried it. Afterwards, I kneaded the bonnet with Petzold Magic blue. After that cleaned with IPA about 50:50. Since the car is not very old and the hood looks good I left the polishing away and am immediately to seal g passed. I did this even in a range with an applicatior always in the cross stitch, did not let it dry and immediately removed and polished out again. Besides, there was no sun and it was around 22 degrees and hardly wind.. Now I noticed and then the following. Before the sealing and after the treatment with IPA, the surface was a lot smoother. What is this about? When I go over it with my hand, the paint just feels stump there. You can see nic hts, but it’s not as smooth as before after sealing… Besides, I discovered something on one half of the hood. Unfortunately I didn’t look so extreme before sealing and can’t say if it was before, but I take it strongly. I can’t describe what it is, but you can see it in the photo something compared to picture 1 to picture 2. You don’t feel it. Can someone tell me what that is on the paint?