Hello Together I have some basic questions about DPF values in VCDS at VAG 1.6 CR-TDI with 128tkm. I have the latest VAG-Com-HEX-NET2 interface version with the latest software in use. Current head of Scan-LOG: Wednesday,17,August,2022,17:51:52:51904 VCDS — Windows-based VAG/VAS emulator runs on Windows 10 x64 VCDS Version: MFT 22.3.1.7 HEX-NET2 CB: 0.4615.4 Data status: 20220523 DS338.01.MWB data button grayed out Everyone always talks about MWB data to read out. ir is the access button on MWBs-8 grayed out, so I always read out the Erw.Measurements.Do I do something wrong or is the MWBs reading not possible/locked on my engine? Or is there an extended access? Wen Yes ,wie?2.Limit values for DPF loading and its consequences I have read out the following values: IDE00433-ENG103279 Particle filter: oil ash volume MASS_ASH_PF 38.4616245 g IDE01409-ENG102169 Loading limit for service regeneration Ash Mass Diag 40.00 g IDE01410- ENG102169 Loading limit Overload Ash Mass Diag 50.00 g IDE06060-ENG111632 Loading limit: Ash load Particle filter C_MASS_ASH_PF_LIM_TEST 70.00 g I am just before the loading limit for Service Regeneration Ash Mass Diag 40.00 g and will soon exceed it.What effects can be expected after crossing this limit?Just as later will the consequences of the load limit overload Ash Mass Diag 50.00 g? charge Particle filter-C_MASS_ASH_PF_LIM_TEST 70.00 g, to my knowledge, has the consequence that the soot-load-regenerations are no longer possible and the DPF has to be cleaned or replaced. That’s far away, but only for information in case:How exactly does the engine get stuck? Does it immediately refuse the service or how does it go exactly further? How far and how can you drive ggF. then?3.Regenerations Soot-load IDE00434-ENG102050 Particle filter: Soot mass calculated net-MASS_SOOT_SIM_PF 14.96 g IDE00435-ENG101197 Particle filter: Soot mass measured-MASS_SOOT_PHY_PF 5.78 g The soot load regenerations are currently running automatically and refer to the value of soot mass calculated-MASS_SOOT_SIM_PF. At reached 24.0g the regeneration starts and ends at 6.0g.Is this generally so normal?What changes after exceeding the load limit for service regeneration Ash Mass Diag 40.00 g?Thank you very much in advance.