Hello together, I was today in a modern washing machine with connected vehicle preparation. With the vehicle conditioner I had had a few funny dark stripes on the white relatively new paint of my new polo (10/2013) removed. While I still had to wait a bit for the expert I watched how the one car had waxed and polished “ruckzuck” (in 10 minutes he had waxed half the vehicle – so long I had to wait until he had r started work was finished and could take care of me) Then I immediately asked what he was using, because I was quite enthusiastic about how fast it was. He said that he took Würt varnish seal and showed me the flat. I then looked on the Internet what there is under Würth varnish seal and found only this: Würth varnish seal PINK 1 liter. That will have been it then. I said that it was probably “formerly” always a problem the wax was not on the K A: What kind of experience do you have with it? (Würth lacquer sealer PINK) B: With such a new varnish (Polo is from 10/2013) it is enough to drive through the washing machine and then lubricate it with it, or ? (some “small impurities” are probably going away with it) (If I use it in – say in 1 hour – with the I know that most “hobby car caregiver” would never drive through the washing system, but I don’t want to invest “too much work”. (better almost none) I can’t have “80% success” with every once in a while. 100% I don’t want to go to. Link where I saw the product:http://www.ebay.de/…/2713560938?… C: H Do you have another supplier on the Internet with a much smaller container? D: What is a “press sponge”. This is in the instructions for applying. Greetings Braver Polo PS: Thank you for your answers in advance.