Hello forum, I have registered today to get to a problem where I just can’t get any further…Vehicle: Mitsubishi Dion, year 2000 (unfortunately not selectable in the forum, but similar to the Scpace Runner)Error picture: The turn signal does not work regularly. Warning flashing works. The turn signal goes when the lever first sets (right or left is no matter) and IF the ignition turns on. Then it flashes in the chosen direction. If you then choose a different direction, v The Blink direction does not change. Thus, the change of the Blink lever is only recognized if the ignition is turned off and on again. The same can be achieved if the plug on the steering wheel is pulled off, which is responsible for the Blinker wiring and plugs in again. As a rule, the Blink lever change is detected both when pulling and when plugging.What has already been tested: I checked all fuses, the relay and the wiring – especially the grounding. b actually two defective/dead fuses and a grounding connection that did not work cleanly. However, that was not the case. In the wiring it is the case that it is a converted right handlebar, which was converted to left (bin in South America). The wire harness extension was simply twisted and wrapped with insulating tape… I now soldered all these and covered them with shrink hose. Before, one could create a “reset” by shaking, probably because This is now over. I also checked the voltage of the battery and can confirm that it cannot be the cause either. Does anyone have any idea how to proceed with the search? The relay works fine, because the blinking actually works, if you use the said procedure with ignition or plug in/pull in again. The fuses should now be no longer a question. Wiring and/or grounding there are still extremely many construction sites. I also tested the cables from the switch to the relay box. All all throughout and no short on it. Be happy about every tip! Best regards Karsten