Hello everyone, today when changing oil (the first one after I changed the pleul bearing shells) have to find out that at the verbination (the 2 thresher) from the trouser tube to the cat the exhaust gases escape. The triangles already look quite finished, as well as the burnt-out screws, with one was already a lot of air in all directions. Short question: is there a favorable variant to repair this? The expensive would be the trouser tube and the cat to exchange. But can hardly imagine a n Weld your triangle to the cat – so imagine it, but the sheet is so thin that it won’t last long. I would be very grateful for tips. Greeting DD-driver