Hello Motor Talker, I found something about my Omega again, but nothing here in the forum at Motor Talk, which describes my problem. So I start slowly, My interior blower works on all power levels,but the conversion probably not right,or not at all. So if I have the position to 0,and then the air-conditioning switch runs the blower motor,but nothing gets cold( probably runs at the smallest level). I turn off the air-conditioning switch again also d If I then put blower on 1-4 then in the middle comes cold (outside temperature) air, put on cold but down in the footroom hot air. I have not so much idea of crafting(fear something wrong or to break) but try it anyway.Have seen with me that behind the glove compartment a hose is loose,to see where the comes to I have removed the HSF,and also found where the hose comes in,behind the Central console,which will be another fuzzy egg to build back like that,I need to see how I get that back in there.. Then I removed the controller unit,to see if the pressure hoses are all fixed,and have checked every single one by hiring the blower and turning at the distribution whether anything happens,pushes/sucks,but nothing happened in no position.I have no plan,I have noted the occupancy of the hoses times which are as follows, the control unit seen from above is not fully developed.Blue is above,green is below,yellow is left,and right is brown,no one of the hoses does anything neither suck nor blow.Maybe you can help me even further,I’m almost at the end.But the worst is still the one with the air above cold and below hot,although put on cold.The blue tube goes right behind the glove compartment into a can?And the yellow somehow disappears forward engine compartment?And the other both, brown and green I haven’t found yet.And the air conditioning doesn’t work either,the switch seems to work,(Blows in position 0 at ignition smallest stage)but does not have the indicator light in it 2 pieces does not glow at both can not be both defective or yet.So that was it from me first,I am grateful for any help here in the FORUM.