Hello, I have been in possession of a V50 2.0D Bj. 2008 Repleitung bought for about 1/2 year – not everything exactly as with my V50. The 4 screws of picture 2 remove metal frame (at the right bottom is a hose attached, on the engine block and on the frame it is clipped) drain screw connect a hose and put under the car into a glass or container (suitable for diesel). (we have taken from the brake fan to pump the hose) Open vent screw – A Open pale screw until diesel runs into the container !! don’t turn out !! about 1/2 liter then make drain screw again !! don’t bang on !! close plug, 2 diesel lines (in, out) turn on lid from filter container (27 6-kant nut) remove filter filter container clean seal ring at filter lid exchange (grease) press filter in lid and insert filter lid again until the stop pin is screwed on. connect plug, 2 diesel lines (point 3) Metallra reassembly hmen with the 4 screws (point 1) Ventilation: Aerial screw connect a suction pump, loosen and pump until no air bubbles are visible in the hoses. (We have taken the manual ventilation pump for the brakes) Start, start briefly, start again, repeat point 8. Make point 9 again 1 time. Start with starting aid spray: 1 person Starts – 2 person sprays into the suction nozzle (cooler grill right side) car runs. The 4 screws from picture 2 remove metal frame (at the bottom right is a hose on it, on the engine block is hooked and on the frame it is clipped) unscrew trolley, unscrew protective plate (7 screws) unscrew oil drain screw inner hexagon (screw container ready), open filler screw. Unscrew the 3 screws (torx nut), tilt flange from the oil extractor to the front) unscrew the oil filter cover (27 6-kant nut) and lift the lid with filter or tilt it. Remove oil filter, clean lid, replace sealing ring thread the lid with filter again and screw it on !! do not bang on !! spray the oily places with brake cleaner a little. oil drain screw replace the sealing ring if necessary and screw it in again. !! do not bang on !! put the protective plate back on, let the car drain again. fill in suitable oil only up to the maximum oil measuring rod approx. 4.5 liters Start the car run about 1 minute, wait a bit, oil level controli fill something if necessary. Fill in between min – max not too much. Tool: 27er 6-kant nut, torx nut set, ratchet set, venting tool (brake vent set with hand pump or dgl.), starter spray, the usual when screwing around on cars.