Hello, I just came from the AB and there I had to realize to my horror that with my S60 from speed 140 the brakes generally fail: Tempo 240-250Km/h for test purposes a full braking attempt (AB was empty!). The pedal could be pressed a bit far, however the braking effect was maximum 1/3 of the expected delay. I then pressed the pedal with full foot force, no better delay any more. Shortly afterwards the message in the display : DTSC Off, Ge White as a lime wall slowly continued. After 2 minutes the error message went out. Again fully into the iron (about 100-110 km/h). Everything as it should be, strong delay, with the typical ABS noise (which was missing at high speed). New attempt (AB still empty!!!) 140-160 km/h Attempt to complete braking: result as on the first time. Display message: DTSC off- speed decrease. Again accelerated to 140-160 km/h and full Into the brake. Strong delay, but without ABS “tue”. When the warning message again tried a full braking. Result repeatedly frightening: maximum 1/3 of the braking effect….. At low speeds everything seems to work best, I tested that, but as soon as a higher speed is driven, I can no longer brake properly (if DTSC is switched on). What madness, Volvo and the brakes…. I’m just happy that I can get through a brake. If I fly at 250Km/h to a stray truck, I have no chance to slow down the vehicle quickly enough, which would probably not be a problem with a really funcratizing brake. My estimate is that I drive at least 180-200Km/h (!!!) , while I should actually be at 100Km/h… A catastrophic condition, there is no error message before. And if it comes to that, you look stupid until you have a No, no, no, no, no, no, no, no.