Hello, I have “restored” my engine in the last few weeks, so everything is back in. Now everything is back in, only unfortunately my car does not start. Light, turn signal, radio etc. work, if I turn the ignition key at level 3, the dipped light goes out but nothing happens, it does not clack from the starter. What I have already looked at is: – petrol pressure is there, pump works and fuel can be lit. -Zündsunken is neither at the spark plug nor directly behind the ignition coil. I changed the tip of the divider and the finger of the ignition distributor. – cabling is so far right, plugs all in it. Mass cables still look “good” – after each other I held the two thick plus cables directly to the pin on the starter but there nothing turned. -Zündschlüssele I also tried both -On the motor everything is mechanically ok, ignition times and so are also right. I have really little idea of electrics and don’t know where to start. elesen. Thanks for further ideas, actually I had to drive back to work before Monday, that was probably done.