Since I have now planned to overtake my omi, after it was first technically restored, now also finally to overtake body, I ask here simply for practical tips of experienced screwdriver colleagues. Especially underbody, and some interspaces were simply not noticed by the previous owner at all in the last years, therefore the “gammel” spreads so slowly, and it is time to put the (still surface) rust to rest… So the question, how did you drive your Omis the Brown Pest out of the dress, and make sure that she doesn’t come back again? Mechanical derusting is clear, and that has to be sealed afterwards so that the gammel no longer has an attack point, but what construction from naked sheet metal did you use and have had good experiences? Strip sheet metal, then lubricate liters with fertan, primer on it… in edges & Palatinate Mike Sanders pure… Gives mass-wise products, suggestions and ideas, but which are the best solutions ? Please for tips !!! (Is certainly also interesting for other Omegans) EDIT : Please for a factual Threat, maybe this would be something for the FAQ ??!!