Hello all, I’ve been having problems with the error message transmission for a few days with my Picasso 1.6 HDi BJ. 2009 broken. Due to the upcoming holidays I didn’t even get an appointment for fault diagnosis anywhere, but only in the KW2. However, it has been suggested that a repair would not be very likely worth it. Which would of course be a middle disaster for me. So I’m now looking for possible causes. A few days ago came the Me When driving, everything was fine, but after turning off, I couldn’t drive backwards anymore. On the 45km drive home, everything was fine, without any problems. The reverse was also working again at the finish. On the next start, again, an error message “Drives made perfect and problems to start the car, because “N” was only allowed to dial in after some time. Then wanted to go to the workshop, the same problem. Could only be done after several minutes with switching off and lever movement “Pick to start. On the way I just let the car run. Back did not go at first. After a few switching attempts also the reverse movement worked. I put it in “N”, he also held the position, so the car can be started. However, I do not dare to drive so anymore, because of fear of not being able to start on the way. As described in a contribution from the Grand Picasso, a defective board, at the switch lift, could be l probably explain the problem and would still be very manageable from the effort. However, I do not want to screw around before I have a diagnosis. Therefore my question: Is a meaningful error code displayed in the circuit board? What cause could there still be for this error? Which error codes would then be displayed? Does it make sense to read the error code with a “normal, simple” diagnostic device or does it have to be a professional device? Thank you in advance s for your tips! I am grateful for every hint. ?