Moin, I’ve built a cruise control so far, worked so well! Look here on page 35http://www.waeco.com/tmp/MS_50_EB_10S_01.PDF With the test “A” everything only works exactly when I step on the clutch, the diode does not light up! And on page 36 the test “B” is described, that also works as it is only there with the clutch not. Don’t understand that anyway as completely as this is supposed to work as the connected one! Look at page 9 there is the switching pl The clutch switch has 2 connections and the one cable goes on the output from the brake light switch and the other again to the control unit. But I don’t understand how this should work… if I do NOT step on the brake but for that, the cruiser should also switch off the clutch but how should he recognize this??? There is no signal, so voltage +12V only come on the cable when I step on the brake so I don’t understand how the function works. can anyone explain this to me? As I said, everything just works out I can’t set the speed during the ride… I don’t like this clutch switch that was there anyway, can’t I use another original switch? Greeting Christian