Hello you guys, as you might see, I’m pretty new here. But read articles from Motor Talk for quite a long time. Now I have a problem: I ordered rims that I got mounted yesterday. Was totally happy that I could afford rims, because as a student you don’t have the money so thick. When they had then mounted the rims, I looked at them and saw that they were already quite dirty. So drive to the next washing system and as ic h got off to buy the card, I see that there are already some flaws on a rim. But I didn’t even drive half a kilometer with them yet! Thought first that it would be dirt, but when I looked at the washing machine again I saw that it was really macking. So I went back to the tyre dealer, however, he said that the macaws could not come by any way from the assembly. That would be quite untypical places. There would be a stone or something like that. (The funny thing is that the makings are arranged radially and 2 spokes are unharmed)! I tried to explain to him then that so Macken can not cause a stone (see photos) , but he did not want to admit to me a montage mistake. When I was at the sport in the evening I spoke again with a car master. He also looked at the macaws and said something would happen if one had used a wrong essay, the essay for a steel rim. So I went there again today, but again no success. The mistake would not be with them. I would have had a lot of bad luck. But I didn’t drive even 1 km with it. In my opinion, the factory town screwed it up, but doesn’t want to admit it… What do you think I could do there? After all, a rim cost 98 € and for me already a lot of money! I am very grateful for your advice! (I can also send the pictures again in the original size by mail or so)