Hello, maybe one can help me. I have recently changed coupling rods (for lowering purposes) installed on my Phaeton without lifting the car into the “car lifter mode” on the stage (out of ignorance). Since then I have a wedge suspension…toll…high and low at the front. The coupling rods are installed properly, but it shows me in the display “Niveau Fehler Werkstatt”. I know, a Phaeton is not put deeper etc., but it is always a matter of taste, or ! Otherwise we would all drive a Daihatsu applause if all had the same taste., I have already looked for it, but found nothing about Google. Was then with the friendly, but did not get away the error again (have they never been told me yet). How is the further procedure? Old coupling rods in, the car have changed again, new coupling rods in and the software/values in the control unit.