hi leutz, I got a new monoamp and would like to wire the whole gun. I now have the following to connect: ma audio hk1997 will run at 1.2 kw and my good old 5 years amp for the fs will run at 400 rms the hk is secured with 60 A and the old amp with 75 A. The old amp was connected over 22mm2 cables…. now the question: 1. how much mm2 do I need for the new wiring? I originally thought about 50mm2 but if necessary also 35mm2 would be sufficient, would also cost-effective stiger…. 2. what does it look like with distributors, do I have to use distributors? I mean with this…. I come from the request. with 50 or 35mm2 and then spread over a block on both stages with the existing 22mm2, or is this also possible to distribute directly over the existing cap? 3. is it advisable to use the cap for both amps or is it enough to switch it just before the bassamp? thx already for your infos… sers nigon