Hello community, I have been standing here for a few weeks an outlander that went out during the ride and couldn’t get started any more. I measured the pre-shipment pressure which was at 0bar. I then removed the pre-shipment pump and saw that the pump hose still goes on a valve and then only up to the output/direction motor. I put the hose directly from pump to top, then the motor jumped with bitsl starter turn on. Then I have a new pump mi t slinging pot ordered because I assumed that the valve in the pump is defective. Unfortunately, the engine still doesn’t start. Error log when I read it the first time is attached, Now only one error is left with the incandescent time control unit.