Hello together, owns a Herkules Rollair compressor for 150,-€ from the Bauhaus. I would like to connect a impact wrench (four-edge with 1/2″ and thread for compressed air hose connection 1/4″. Data of my compressor: – pressure 10 bar – suction power 200 l/min – filling power 130 l/min – engine power 1.1 kW at 230V – boiler 2×8 liters Now I would like to connect a impact wrench there. Will not take advantage of the full power of the impact wrench. but the screws have to be glued in, which makes the screws difficult to get out until the last thread passage. And with 100mm long screws that’s not exactly pleasant….there’s a hit screw. Can I connect a hit screw to this genus there?http://www.amazon.de/…/ref=sr_1_1?… Best regards DJ1312