Hello everybody, I have a very stupid question. I know that I’m about to reap ridicule and hem but I doubt my mind right now. I wanted to check the oil level with my car (MB C220 CDI T-Modell, Br. 204). I put the car on a supposedly flat surface. With repeated control of the oil measuring rod, I found with horror that the oil level is about 4-5 mm above max. (cold and warm measured). g the oil level at just below Max., as it should be (at the test the car was about half a meter further behind, i.e. the front wheels a little higher)). I could not really believe the result, so that I put a 1 m long water level next to the car on the ground. This showed me that on the front third of the vehicle there is a slope of about 1-2 cm to the front. That can hardly be seen with the naked eye! Now I ask myself all the serious things, o b this gradient is sufficient that the oil level cannot be reliably read, so that it is too high around the described 4-5 mm. Does anyone have similar experiences?