Hello together, I would like to exchange experiences about the washing system mode, especially since I have at the moment already 2 times almost brought a system to a standstill. Situation: I use the washing system mode in a system in which I can stay in the car everything is ok. Door grips remain in, PDC/camera goes out etc. Rear axle steering remains fixed. So everything is easy. The problems occur when I drive to a washing system, where I have to get out and the car on a The operator’s requirement is, lock in the car, driving position on N, engine “on” PDC, camera off etc. Up to now, even with my EQC was never a problem. However, the following happens with EQE: – Washing machines mode is on – vehicle is on ready and in N – lock stays in the car and I get off. -> The door handles stay extended and enter the system at some point only after a very long time. -> At the end of the washing system at boarding is the Au to completely off and in P! -> I have to drive every time before the car is pushed off the belt in fractions of seconds to turn the car back on, select profile, fingerprint, then drive to driving level D and out… Is that the plan? Am I doing something wrong? Is it usual that the car runs out completely when it is on N for a while though? How do you deal with such washing systems? Thank you.