Good afternoon. It’s about the 88hp engine. Yesterday a used one looked at. There is the oil measuring rod, the field where the marking is high/low sitting out of yellow plastic and quasi dry, at least no oil drop on it, rather some deposits. Before that with a car or as you normally know it, at least a drop runs down. Besides, it is a bit bent, on the left a few bends, but does not go in so hard. Is it at all the right track rod? Photo can I upload afterwards. At the engine start is Oil OK. Otherwise the engine has also run thousands of km, just under 15-20tkm last year, has now just under 100tkm. Owners said, vllt. too short there knicked, which would not make up any cm by the few bends. Workshop service before 20tkm was also OK, said nothing. Otherwise the engine seemed to run normally, on the test drive of a few km. Purchase advice/what else I noticed later in another fred.