hi, I have a little problem, or ask: I built n peerless definition 6 in the doors. and because there is no suitable end stage there is to eat quickly an old blue point. (overpainted, no longer know exactly what it is for one, I think GTA and something with 2x200W) now I only hung the left TMT and HT over the frequency soft to the end stage, and already with something more than room-laut strength started to distort. then I have the left side of the bridge t on both channels, exactly the same thing, there is no piece of louder without distortion. and the tweeter plays far too loud, although I already have it on the -6db connection. I controlled the poles several times. now my question: that the end stage is no good and is probably overburdened is clear to me, nevertheless I would have expected at least that she should create half the system. could that be that I did something wrong? after all, the end stage used to have a magn atube driven (hohoho, ch white) which may not have smoked much power, but with a 28cm bassophone probably more than the small, half, peerless, that still runs with a highpass at 100Hz?! I mean if cih now take the cardboard inscription “80W”, sometimes assuming that is sinus (?) the half system needs only 40, and that should still somehow get the stage, without mercilessly going into the bags ?!