Hello, with my Formentor I have unfortunately only constantly problems. The biggest problem, however, is that the car almost always pulls to the right. Straight ahead is almost never in, in very rare cases it also pulls to the left. On my first workshop visit an axle measurement was carried out. One could see small deviations, see picture. These were allegedly corrected. Now the car still moved to the right after that. Again was allegedly measured, but no deviations were observed. Now I have new tires and again the same problem. My question: can you tell by the protocol whether the car with the red marked values would rather pull to the right? I think they have “corrected” nothing on the first visit. Meanwhile, I also believe that they just don’t want to do something about it because it is still in the warranty. According to another Cupra workshop, one would have only up to 10,000 km on sol The master of this cupra dealer has been driving along and also found that the car is moving to the right. However, an axle measurement would cost, since I have over 10,000 km on it and the other workshop is actually still in the obligation to repair the car.