Hello, now also have a Sprinter 315 cdi with EZ 10/06. Now the engine control light has turned on and I no longer have any power. Switching the engine off and on at short notice remedy. When reading out with Torque come following errors: P0101 – Mass or Vol. air quantity meter circuit range/operation problem (declared as “current lazy”) P1955 – no description, according to Google a not relevant error regarding NOx (as “pending lazy” declared) P2011 – flow control ngsystem in the intake manifold (bank 2) – fault/interruption P2134 – circle sensor/switch F throttle/acceleration pedal position – signal discontinuous P2672 – injection pump timing offset (for this I have unfortunately found no German translation) In another topic it was written that it may be on the throttle valve if several errors occur at once. However, since I have another engine, the OM 646, advised me “saft otter”, better to open up a new topic Viellei I would have to delete the mistakes to see which ones are left over. Maybe they are older. Hope you can help me. Thank you very much! Greetings, air pump1983