Hello, I have a Renault Kangoo in the van version and since I can’t use the rearview mirror because of a kind of partition, I would like to use a rearview camera with a monitor instead of the rearview mirror. I removed the rearview wiper and plan to mount the camera in the rear door at the resulting opening and “look out out”. So far so good. It would be great if I had the rearview camera electronically on the freed cables for the rear The connection consists of 3 single cables – the cable in the middle leads 12V while the other 2 on the left and right of it is equipped with 0 volts (mass?). I tried to connect the camera once but unfortunately it didn’t work. The voltage breaks immediately from 12.5 volts to 4.7 volts as soon as the camera is attached. I also tried the switch for the rear panel. I tried to find out as much as possible about the installation and wiring of the taillight wiper and found the attached pictures. Since Renault is a French brand, the colour codes of the cables are in French: * YES = Jaune = Yellow = Zündplus (switched plus) * NO = Noir = Black = Mass * GR = Gris = Grey = ? The corresponding component (backwind wiper) is in the first two pictures with the Number 211 marked and in the last picture with number 12. Does someone know each other here and could tell me if it is possible to operate the return camera to the electrical connection for the rear windscreen wiper, and if so, how to do it and what to consider? P.S.: The return camera is an AUTO-VOX TD2: https://www.amazon.de/…/B07DC46C5H