Hello Bikergemeinde, a brand new HONDA NC 750 X DCT has been available in my garage for a few weeks now. Since I want to do some larger tours in the near future – also several weeks – a suitcase system has to come up. After several mistryes with incompatible suitcases and carrier systems I have now decided for the following system from Hepco & Becker: Suitcase:https://www.louis.de/…/10026315?… Carrier system:https://www.louis.de/…/10023470?… Both are compatible with each other and s It should also fit the NC 750 X DCT, BJ 2017 (R90). However, during the installation I had to find out that although the mounting adapter could be attached under the seat of the socifixion, the actual case carrier was not attached to the holding adapter. The problem was/is due to the different angles of the holding adapter and case carrier (Figure 1 + 3), so that both can only be mounted under large (in my opinion too large) voltages. My question is: Has anyone ever installed this system on the R90 (NC 750 X DCT)? Are there similar experiences? And if so, how did you proceed? H&B offered to build the system in their own factory on my motorcycle “for reasons of collec tion”. Be sure that everything fits. However, I would have to go to Pirmasens (430 km). I would be even willing to do this, but would like to know beforehand if ever I had to go to Pirmasens (430 km). and has had similar experiences.