Hello together, I am unfortunately currently hanging a bit in the engine room of my dear 9-3 Combi BJ 2005. A few days ago the SID registered with the message that the left flasher light was defective, which was also noticeable when the flashing was real. Strangely, the flasher went off again for a few minutes without a message, but at some point the error indicator came again. So a lamp worried and cheerful thought that the change could not be so difficult. Until the release of the left headlight is all good, I would also be able to reach the two larger bulbs well, the rubber caps would both be easily removable. Where it is then hooked the arrival to the flashing light, there I simply find no bayonet closure (as according to the manual must be available), which I just have to turn to come to the flashing light and to exchange times. I discover there further on side only a cable feed, which goes to a plug – but also if I dis I don’t feel a rotatable lock for the “blinker room”. I put everything back in the first attempt after frustrating popping and went on for the first time. Since yesterday evening, about 12 hours after that, I now get a non-functioning xenon light on the same side and even the position light is not on. Speak now in the left headlight no more light at all… the latter makes for me rather de n impression, as if I had worked too dusily while re-plugging the cable, I evaluate that again tomorrow, but where is my desperately sought-after access for the flashing light? Someone a hot tip? Or am I missing something completely different? Thanks for all the trouble!