Hi guys! I have a problem with the electronics of my EN500A. And it doesn’t start after long standing. I’ve already done the following: I changed the battery and bridged it on a car. So it should have enough power. I’ve already changed the starter relay and the relay for the starter circuit. When the starter button is activated, the relay ratters for the starter circuit. However, no signal seems to be between the two relays. ommen. I connected the starter directly to the battery and it rotates. I short-circuited the starter relay at the connections for the relay for the starter circuit. Then the starter also rotates. The main fuse is also ok. I just don’t know how to check or measure at which point in the Junction box or on the cables of the faults. The cables from the JB go in one strand to the handlebar and are not visible without cutting it. I möc hte likes to measure, but I don’t know where voltage has to be when the start button is pressed. The fuses are all okay. And since the relay for the starter circuit is clacking, that means for me that the circuit with ignition lock, on/off switch, start button etc is okay, right? That would mean that it can only be due to the connection between the two relays, or am I wrong? I’m so slow to be really perplexed and happy about every answer! Maybe there is j and an idea. Greetings, Oli