Hello Motor-Talk! I have had a Proceed GT (BJ 2019 and 50000km) for almost 1 month, which annoys me a bit. To the problem: already at the third start, the engine has jerked like hell. The idle speed was at almost 1500 and the torque indicator rose wildly up and down. During the first 5 seconds also the engine control lamp flashed quite fast. After about 1 minute the engine catches again – acoustically and noticeable – but more than 20 kmh could not speed up. The car does this at about every 5 start – during the ride there are no problems. Because of the problem (and brake disc change) I was in the workshop last Friday. This has installed new spark plugs in the hope that the problem disappears. That then lasted until Tuesday because parts were apparently not delivered. As far as so good. In the second time I tried only the first time. I thought after 2 days I could ask if they have already found something and if they can estimate a time already. Now the reason I’m actually writing to the forum: The mechanic on the phone said they could only look at the car 2 times and he also had the problem 1x. In the one minute (!) kon But they didn’t notice anything. He said that would take time.. I’m an absolute layman, but for me it sounds like they have the computer on it in the hope that it will show them the exact error – once the problem occurs. Is that normal? With such an approach I’m afraid that the car will still be there for months. Shouldn’t you find the error in another way? With visual inspection, measurement of the cables oĆ? As I said, only a layman have your ideas w as I can do there? Or is this kind of solution normal and I’m just too impatient? It’s an official KIA workshop, wg. guarantee. Thank you for tips and suggestions. LG