Hello , we have in operation a new Trafic 3 with factory-side cooling unit , as in the back of the cargo space with full lining in white plastic . Now we have the following problem , the FHZ was ordered without AHK and delivered and now we should install at its FHZ an AHK with 13-pin E-set , according to its instructions it is nevertheless so that one in the cargo space also has to clean but here is an access yes not possible , how to get here still at these places ? , moreover I still have the question whether ev. the cable set of Trafic 2 vehicle specific. could also fit to the Trafic 3 , especially since I would have at least 3 pcs. in stock , but unfortunately only 1 FHZ of type Trafic 2 box runs with us and thus these are no longer needed , in addition I would have even a UNI 13 pole , all are for with parking sensors however partly with or without hunter-Tronic . Are all of hunters . Can send me here ev. someone cable plans from Trafic 3 or Trafic 2 back , gladly by PN or mail or ev. otherwise help me on the topic, Renault workshop doesn’t know here either and should be here directly to the factory service, since they also don’t come any further because of the interior installation. However, think that this should be possible here nevertheless without great effort, especially since you can extend the taillights all accordingly and even the rubber seals are accessible, can also come to the plugs inside, but according to hunter here two cables would have to be best cable tree to be connected where I can not reach so and now look for another solution, so far I have only looked or the installation plan of Jäger (no.: 748282 – 13-pin) so material not yet. Who can help me there, experience yes already mounted tens of AHK. Would be grateful about numerous help to this. Greetings