Hello, It’s about a Ceed JD SW, where the battery was empty. So it was removed, charged and reinstalled. Before it was removed, the vehicle was opened manually with the key, as well as again for installation. From now on, the flashing behaviour changes when the vehicle was closed with the remote control. Before the incident with the battery, the flashers signaled after using the remote control with 1x flashing that the system is sharp and the vehicle is closed. The switch will not open for a while, but it will light up for a while in the centre console of the pushbuttons for the manual locking of the vehicle and then go out. This will take 30 -60 seconds. In between, the vehicle will give an audible locking pulse to the doors again. If I press the flashers 1x again on the remote control, the opening by remote control will always be confirmed by 2x flashing. That’s normal. Does anyone have an idea why the system doesn’t more automatically sharp and flashes 1x when closing? Greetings Robert