Hello 306er, I have been having problems with the veins in the left driver’s door for some time. Today I changed the wire harness, however, I could not assign 6 wires. The wires were weathered so strongly in the connecting rubber that they had broken through and therefore no colour assignment was possible to me. It is about 3 red and 3 wise wires. I could successfully assign all other wires by measuring because the core color in the repair cable kit was not with the installed in the vehicle Two of the three red veins I could assign in the two plugs which are on the wire harness where the veins end. 2 veins go into the white coded plug. The third vein would then be the one which cannot be measured. Here, however, I lack the assignment of the plug pin to the door plug pin. With the wise veins it is a bit more swirier. Here I found a vein in the gray coded plug and one in the white coded plug (32,5M Ohm). Also hi unfortunately I lack the assignment of the plug pin to the door-plug pin since the cables were already unmounted during dismantling. Can you possibly help me with the pictures further which vein belongs to it? Achso maybe this still in the driver’s door helps you with the following things: – electric mirror (left and right) – electric window lifter (only front left and right) – door speaker Thank you already for your answers.